Physics Semester-2 ICSE Specimen Paper Solved Class-10

Physics Semester-2 ICSE Specimen Paper Solved Class-10 for practice.  Step by step solutions of ICSE Class-10 specimen model sample paper.  During solutions of semester-2 Physics specimen paper we explain with figure , graph, table whenever necessary so that student can achieve their goal in next upcoming exam of council . Visit official website CISCE for detail information about ICSE Board Class-10.

Physics Semester-2 ICSE Specimen Paper Solved Class-10

Board ICSE
Class  10th (x)
Subject Physics
Topic Semester-2 ICSE Specimen Paper Solved
Syllabus  on bifurcated syllabus (after reduction)
session 2021-22
Question Type  Descriptive Type (as prescribe by council)
Total question No. 5 with all parts (Sec-A&B)
Max. mark 40

Solved Class-10 for practice Set of Physics Semester-2 ICSE Specimen Paper 

Warning :- before viewing solution view Question Paper


SECTION A
(Attempt all questions.)

Question 1:

Choose the correct answers to the questions from the given options. (Do not copy the question, Write the correct answer only.)

(i) Pendulums A, B, C and D are tied to a flexible string PQ and are at rest. Pendulum C is disturbed. Which of the following statements is true?

Pendulums A, B, C and D are tied to a flexible string PQ and are at rest. Pendulum C is disturbed. Which of the following statements is true?

(a) Only pendulum C will start vibrating.

(b) Pendulums A, B, and D will also start vibrating but A and D will vibrate with the maximum amplitude.

(c) Pendulums A, B, and D will also start vibrating.

(d) Vibrations of pendulum C are forced vibrations.

Answer : (b) Pendulums A, B, and D will also start vibrating but A and D will vibrate with the maximum amplitude.

Reason:- due to resonance

(ii) Which of the following is not a characteristic of parallel combination of resistors?

(a) If one resistor is fused, the circuit does not become open.

(b) The total resistance R is given by the formula

The total resistance R is given by the formula

(c) The total resistance becomes less than the least resistor, present in the combination.

(d) The current through each resistor always remains the same.

Answer : (d) The current through each resistor always remains the same.

(iii) Which one of the following statements is correct?

(a) Live wire has zero potential.

(b) Fuse is connected in a neutral wire.

(c) Potential of live and earth wire is always the same.

(d) Earth wire is used to prevent electric shock.

Answer : (d) Earth wire is used to prevent electric shock.

(iv) The diagram below shows a free conductor AB is kept in a magnetic field and is carrying current from A to B. (To avoid confusion complete path of the circuit is not shown) The direction of the force experienced by the conductor will be:

The diagram below shows a free conductor AB is kept in a magnetic field and is carrying current from A to B. (To avoid confusion complete path of the circuit is not shown) The direction of the force experienced by the conductor will be:

(a) Up

(b) Down

(c) Towards N

(d) Towards S

Answer :(a) Up

(v) The diagram below shows a magnet moved near a coil along its axis. Which of the diagram shows correct flow of current during this motion?

The diagram below shows a magnet moved near a coil along its axis. Which of the diagram shows correct flow of current during this motion?

The diagram below shows a magnet moved near a coil along its axis. Which of the diagram shows correct flow of current during this motion?

Answer : option (a)

(vi) The meaning of the statement ‘Specific heat capacity of water is 4200 Jkg-¹K-¹ ’ is:

(a) Water needs 4200 J heat to raise its temperature by 1 kelvin.

(b) To raise the temperature of water 4200 J of heat is absorbed.

(c) 1 kg water absorbs 4200J heat to increase its temperature by 1 kelvin.

(d) 1 kg Water needs 1 kelvin temperature to absorb 4200 J heat.

Answer :(c) 1 kg water absorbs 4200J heat to increase its temperature by 1 kelvin.

(vii) 200 g of ice at 0ºC needs _________ heat to melt. [Specific latent heat of ice = 336000 J kg-¹]

(a) 6720 J

(b) 67200 J

(c) 672000 J

(d) 67.2 J

Answer :(b) 67200 J 

Reason Q = mL

= .2kg x 336000

=67200 J

(viii) The radiation with maximum penetrating power is:

(a) γ

(b) β

(c) X-radiation

(d) α

Answer : (a) γ is correct

(ix) Resonance is:

(a) A forced vibration in which amplitude remains constant.

(b) A forced vibration in which frequency of forced vibration is greater than the free vibrations of the body.

(c) A forced vibration, in which frequency of forced vibration is equal to the free vibrations of the body.

(d) A forced vibration, in which frequency of forced vibration is less than the free vibrations of the body.

Answer :(c) A forced vibration, in which frequency of forced vibration is equal to the free vibrations of the body.

(x) The nuclear radiation which gets deflected towards negatively charged plate in an electric field is:

(a) Gamma

(b) Ultraviolet

(c) Beta

(d) Alpha

Answer : (d) Alpha is correct


SECTION B
(Attempt any three questions from this Section.) 

Note: Solutions of Sec-B given at Bottom

Question 2:

(i)

(a) Calculate the total resistance across AB.

Calculate the total resistance across AB.

(b) If a cell of e.m.f 2.4 V with negligible internal resistance is connected across AB then calculate the current drawn from the cell.

(a) Which will absorb more heat, 10 g of ice at 0º𝐶 or 10 g of water at 0ºC ?

(b) For the same mass of ice and ice-cold water, why does ice produce more cooling than ice-cold water?

(iii) The diagram below shows an insulated copper wire wound around a hollow card board cylindrical tube. Answer the questions that follow:

The diagram below shows an insulated copper wire wound around a hollow card board cylindrical tube. Answer the questions that follow:

(a) What are the magnetic poles at A and B when the key K is closed?

(b) State two ways to increase the strength of the magnetic field in this coil without changing the coil.

(c) If we place a soft iron bar at the centre of the hollow cardboard and replace the DC source by an AC source then will it attract small iron pins toward itself when the current is flowing through the coil?

 

Question 3:

(i) The diagram below shows a cooling curve for 200 g of water. The heat is extracted at the rate of 100 Js-¹. Answer the questions that follow:

The diagram below shows a cooling curve for 200 g of water. The heat is extracted at the rate of 100 Js-1 . Answer the questions that follow:

(a) Calculate specific heat capacity of water.

(b) Heat released in the region BC.

(ii)

(a) Observe the diagram given below and state whether the bulb will glow or not when we switch on K.

Observe the diagram given below and state whether the bulb will glow or not when we switch on K

(b) Is it safe to handle the bulb when the switch is OFF?

(c) Give a reason for your answer in (b).

(iii) Two metals A and B have specific heat capacities in the ratio 2:3. If they are supplied same amount of heat then.

(a) Which metal piece will show greater rise in temperature given their masses are the same?

(b) Which metal piece will have greater mass if the rise in temperature is the same for both metals?

(c) If the mass ratio of metal A and metal B is 3:5 then calculate the ratio in which their temperatures rise.

(d) If specific heat capacity of metal A is 0.26 Jg-¹ ºC-¹ then calculate the specific heat capacity of metal B.

Question 4:

(i)

(a) Which one of the following graphs A or B shows free vibrations in vacuum and which one shows free vibrations in a medium?

(b) How did you come to this conclusion.

How did you come to this conclusion.

(ii)

(a) State the Faraday’s laws of electromagnetic induction

(b) Name one electrical device which works on this principle.

(iii) A nucleus 82X194 emits an alpha particle

(a) What will be the atomic number of the daughter nucleus Y?

(b) What will be the number of neutrons in the daughter nucleus Y?

(c) Write a nuclear reaction showing the emission of this particle.

Question 5:

(i)

(a) Name the electrical appliance shown in the diagram below.

Name the electrical appliance shown in the diagram below

(b) Name the material of the wire used in this device.

(c) Name two important characteristics of this wire.

(ii)

(a) Define pitch.

(b) Two wires AB and CD of same length are stretched by same amount. Which wire will produce sound of greater pitch on plucking?

(c) Give a reason for your answer

Give a reason for your answer

(iii)

(a) Why is water used as a coolant in radiators of a car?

(b) Name the radioactive isotope used to find the age of fossils. Name the radioactive radiation which it emits?


Return to:-    ICSE Class-10 Specimen Paper Semester-2 of 2021-22 

thanks

Please share with your ICSE friends

18 thoughts on “Physics Semester-2 ICSE Specimen Paper Solved Class-10”

  1. i think the 1st ones solution is option c and not option b:
    as, pendulum C is put into motion it oscillates with its natural frequency and since the pendulums A and D which are not of same length as that of C ( so they do not have the same natural frequency as C ),will execute” Forced Oscillations”, as C exerts external periodic force on A and D thus, these vibrations” Can’t Be in Resonance”. Therefore, they oscillate with an amplitude lesser than pendulum C.

    Reply
  2. Some of your answers in english literature specimen solutions were incorrect due to which i got confused and loosed a mark in my pre board .
    you should check the answer carefully before posting them , it was pre board so it doesn’t matter so much but it means so much in boards !!!
    so please post correct answers ….

    Reply
  3. All the pendulums will start vibrating but the natural frequency of pendulum A and D matches so they will vibrate with a much larger amplitude

    the length of the pendulum A is same as length of the pendulum D
    so the frequency of these pendulums will be same

    If You Want I Can Give A Detailed Explanation Too

    Reply

Leave a Comment

This site uses Akismet to reduce spam. Learn how your comment data is processed.

error: Content is protected !!